Add new range/IP

The window serves to set the scope in which the computers in the network will be searched using the IP addresses.

Options:

• IP from: – enter the first (initial) address of the scope.
• IP to: – enter the last (end) address of the scope.
• Single IP address – select if you do not want to add the scope, but only one specific IP address.
• Collector Name: – enter the Collector name which will be performing the network scan.
• Scan each __ h – enter the time in hours, after which the collector should start to search the network again.

Did not find what you were looking for? Ask our technical support team.